Brrrrrrrrr! December has been a bit cold. We expect completion of the upholstry bay this month with heat. We have added quite a bit of equipment by now . We have a fully equiped machine shop in machines and tooling. Enough so that every aspect of automotive machining with only the exception of crank and cam grinding can be done here.That should be up and running by Febuary. We have a Three ton flat deck with a knucle picker and special rigging to gently lift a full sized automobile gently by its tires thus avoiding the potential damage from winching and towing. This truck is also available to do a host of other tasks. In the sheet metal department last summer an older metal lathe (seperate from the two in the machine shop) was added. So now the capability to do metal spinnig to form sheet metal is a reality now. We had taken october and november of to work at these improvements and now will be adding more photos of the cars as we progress. We wish you the best in this very special time of year and trust your individual projects are doing well.